Roland 04672434 用户手册

下载
页码 184
 
44
Chapter 3 Global Device Settings (SYSTEM)
 
Setting upper and lower limits for the patches that can be switched 
allows you to select only the patches you need.
 
1.
 
Press [SYSTEM].
 
2.
 
Press PAGE [
] to display Page 3.
 
3.
 
Press [F1] (MISC).
 
4.
 
Press [F3] (FROM).
 
5.
 
Set the lower limit of the patch selection with 
the PATCH/VALUE dial and [F3] (FROM) or the 
F3 knob.
 
6.
 
Press [F4] (TO).
 
7.
 
Set the upper limit of the patch selection with 
the PATCH/VALUE dial and [F4] (TO) or the F4 
knob.
 
*
These settings are enabled in the following situations.
 
• When the PATCH/VALUE dial is turned
• When patches are switched with the control switches or 
other controls
assign PATCH SELECT INC or PATCH SELECT DEC to 
the FC-300’s control switches or expression pedal 
switches
These settings have no effect on other FC-300 operations 
or operations using an external MIDI device.
The text and icons in the LCD screen may be difficult to make out 
sometimes, such as immediately after the VB-99 is turned on or after 
extended use. The conditions at the place where you are using the 
VB-99 can also affect visibility. Should you run into this problem, try 
adjusting the contrast.
 
1.
 
Press [SYSTEM].
 
2.
 
Press PAGE [
] to display Page 1.
 
3.
 
Press [F1] (LCD).
 
4.
 
Turn the F1 knob to adjust the contrast.
 
Limiting the Patches That 
Can Be Switched (PATCH 
EXTENT)
 
Adjusting the Screen’s 
Contrast
VB-99_e.book 44 ページ 2008年8月18日 月曜日 午後1時10分