Xerox FS 5250 IPC 用户手册
Connections and Installation
Xerox FS 5250, User’s Guide
Xerox FS 5250, User’s Guide
- 22 -
6.5. Connecting the Xerox FS 5250
to the System
After a successful test printout has been generated to establish that the
connection between the Xerox FS 5250 converter and the printer is working
correctly (see previous sections), you are now ready to connect the Xerox
FS 5250 to the system.
connection between the Xerox FS 5250 converter and the printer is working
correctly (see previous sections), you are now ready to connect the Xerox
FS 5250 to the system.
WARNING:
All connections to the Xerox FS 5250
protocol converter should be
made while the power is switched OFF.
1.
Turn off the power and connect the Xerox FS 5250 to your host system
using the twinax cable, and the auto-terminating T-cable.
using the twinax cable, and the auto-terminating T-cable.
2.
When the connection has been made, turn power ON and check that
the CU and READY indicators turn ON. When they do, you have
completed the installation procedure and are ready to operate the
protocol converter as described below.
the CU and READY indicators turn ON. When they do, you have
completed the installation procedure and are ready to operate the
protocol converter as described below.
What if the CU Indicator fails to turn on?
If the CU indicator does not turn ON, this means that there is no
communication with the control unit. You should check the follow ing:
communication with the control unit. You should check the follow ing:
a.
The twinax cable connection from the control unit to the Xerox FS
5250.
5250.
b.
The control unit (is it powered up etc.)
c.
Is the control unit supported by the Xerox FS 5250 ?
(See the section "Supported Control Units" for a list of sup ported con-
trol units).
(See the section "Supported Control Units" for a list of sup ported con-
trol units).
If all three (a. b. and c.) are in order, contact your systems support personnel
or your point of purchase.
or your point of purchase.