Cisco Systems IAD2430 用户手册

Port numbering conventions for the Cisco IAD2435 series IAD are as follows:

Fast Ethernet ports are numbered 0 and 1, from left to right.

The controller T1/E1 port is numbered T1 0 or E1 0, from left to right.

FXS voice port numbering begins at 0 and reaches a maximum of 7, depending on the number of 
voice ports, from left to right.

For the Cisco IAD2430 series hardware and electrical speicfications, see the Cisco IAD2430 series data 
sheets at the following URL:

The operating system for the Cisco IAD2430 series IADs is the Cisco IOS software that resides in flash 
memory.

You can use an ASCII terminal or a PC to configure a Cisco IAD2430 series IAD. The configuration can 
be performed in several ways:

Locally, with a direct connection through the serial port

Remotely, with a connection through the serial port and a modem

Through Telnet and TFTP

You can configure a Cisco IAD2430 series IAD automatically using the Simple Network-Enabled 
Auto-Provision (SNAP) option, or you can configure theCisco IAD2430 series IAD manually using 
several methods listed in 

If your Cisco IAD2430 series IAD was ordered with the SNAP option, no on-site configuration is 
required. When the Cisco IAD is powered on and connected to the WAN, the SNAP application 
downloads the applicable configuration files automatically. For additional information about SNAP, see 
the following URL:

The SNAP option is not available on the Cisco IAD2435 IAD.