Q-Logic 8100 SERIES 用户手册

C–Brocade CEE/FCoE Switch/Blade Configuration
Configure CEE Port

C-6

FE0254601-00 A

4.

Verify the LLDP/DCBX configuration (Transmit TLVs) by issuing the 

following command:

(config)#  do show lldp
LLDP Global Information
  system-name: swd77
  system-description: Fibre Channel Switch.
  description:
  State:                   Enabled
  Mode:                    Receive/Transmit
  Advertise transmitted:   30 seconds
  Hold time for advertise: 120 seconds
  Re-init Delay Timer:     2 seconds
  Tx Delay Timer:          1 seconds
  Transmit TLVs:           Chassis ID               Port ID
                           TTL                      IEEE DCBx
                           DCBx FCoE App            DCBx FCoE Logical Link
                           Link Prim                Brocade Link
  DCBx FCoE Priority Bits: 0x8

To configure the CEE switch port to which the QLogic 8100 Series Adapter is 
connected:

1.

Enter the interface configuration mode for the CEE switch port that connects 
to the QLogic adapter by issuing the following command. In the example, the 
QLogic adapter port is connected to CEE port 0/19 on the Brocade switch.

(config)# interface tengigabitethernet 0/19

2.

Enable the layer 2 switching mode by issuing the following command:

(conf-if-te-0/19)# switchport

3.

Set the CEE port to converged mode by issuing the following command:

(conf-if-te-0/19)# switchport mode converged

4.

Activate the VLAN classifier group 1 rule and assign VLAN 1002 to the CEE 
port by issuing the following command:

(conf-if-te-0/19)# vlan classifier activate group 1 vlan 1002

5.

Assign the CEE-MAP to the CEE switch port interface by issuing the 
following command:

(conf-if-te-0/19)# cee demo

6.

Enable the CEE port by issuing the following command:

(conf-if-te-0/19)# no shutdown