Baldor Inverter Control 用户手册

4-2 Programming & Operation

MN715

The control is in the display mode at all times except when in the programming mode.
The keypad displays the status of the control as in the following example:

Motor Status

Control Operation

Output Condition
Value and Units

When AC power is applied to the control the keypad should display the status of the
control.  If there is no display visible, use the following procedure to adjust the display.

(Contrast may be adjusted in the display mode when motor is stopped or running).

Apply Power

No visible display

Press DISP Key

Places control in display mode

Display mode.

Press SHIFT key 2 times Allows display contrast

adjustment

Press 

 or 

 Key

Adjusts display intensity

Press ENTER

Saves level of contrast and exits
to display mode

Note: The order of display is as shown (scroll through order).  However, the first

display after “Baldor Motors & Drives” will be the last display you viewed
before power down.

Apply Power

Display mode showing mode,
voltage, current & frequency
status.

No faults present.  Local keypad
mode.  If in remote mode, press
local for this display.

Press DISP key

Scroll to fault log block.

Press ENTER to view the fault log
if desired.

Press DISP key

Scroll to diagnostic info block.

Press ENTER to view diagnostic
information if desired.

Press DISP key

Scroll to local speed ref. block.

Press ENTER to change motor
speed.

Press DISP key

Display mode showing output
frequency.

Press DISP key

Display mode showing motor
speed (based on output
frequency).

Press DISP key

Display mode showing output
current.

Press DISP key

Display mode showing output
voltage.