Baldor Inverter Control 用户手册
Section 1
General Information
General Information
4-4 Programming & Operation
MN715
Changing Parameter Values when Security Code Not Used
Use the following procedure to program or change a parameter already programmed into
the control when a security code is not being used.
the control when a security code is not being used.
Action
Description
Display
Comments
Apply Power
Keypad Display shows this
opening message.
opening message.
Logo display for 5 seconds.
If no faults and programmed for
LOCAL operation.
LOCAL operation.
Display mode. Stop LED on.
Press PROG key
Access programming mode.
Press
or
key
Scroll to Level 1 Input Block.
Press ENTER to access INPUT
block parameter.
block parameter.
Press ENTER key
Access Input Block.
Keypad mode shown is the
factory setting.
factory setting.
Press ENTER key
Access Operating Mode.
Keypad mode shown is the
factory setting.
factory setting.
Press
key
Scroll to make your selection.
At the flashing cursor, select
mode desired. Standard run is
shown.
mode desired. Standard run is
shown.
Press ENTER
Save selection to memory.
Press ENTER to save selection.
Press
key
Scroll to menu exit.
Press ENTER key
Return to Input Block.
Press DISP key
Return to Display Mode.
Typical display mode.