Baldor Inverter Control 用户手册

4-6 Programming & Operation

MN715

  

After a new EEPROM is installed, the control will automatically initialize the new software
version and memory locations as if “STD Settings” was selected.  If you need to initialize
the control to the 50Hz / 400Volts” settings, use the following procedure.

Note: All parameter values already programmed will be changed when resetting the

control to factory settings.

Apply Power

Keypad Display shows this
opening message.

Logo display for 5 seconds.

If no faults and programmed for
LOCAL operation.

Display mode.  Stop LED on.

Press PROG key

Enter program mode.

Press 

 or 

 key

Scroll to Level 2 Blocks.

Press ENTER key

Select Level 2 Blocks.

Press 

 or 

 key

Scroll to the Miscellaneous block.

Press ENTER key

Select Miscellaneous block.

Press 

 key

Scroll to Factory Settings
parameter.

Press ENTER key

Access Factory Settings
parameter.

 represents blinking cursor.

Press 

 key

Scroll to STD SETTINGS, to
choose original factory settings.

For 50Hz motors, set to 
50Hz/400 VOLTS.

Press ENTER key

Restores factory settings.

“Loading Presets” is first message
“Operation Done” is next
“No” is displayed last.

Press 

 key

Scroll to menu exit.

Press ENTER key

Return to display mode.

Display mode.  Stop LED on.

Press DISP key

Scroll to diagnostic info block.

If you wish to verify the software
version, enter diagnostic info.

Press ENTER key

Access diagnostic information.

Displays commanded speed,
direction of rotation, Local/
Remote and motor speed.

Press DISP key

Display mode showing software
version and revision installed in
the control.

Verify new software version.

Press DISP key

Displays exit choice.

Press ENTER to exit diagnostic
information.