Nxp Semiconductors UM10237 用户手册
UM10237_2
© NXP B.V. 2008. All rights reserved.
User manual
Rev. 02 — 19 December 2008
266 of 792
NXP Semiconductors
UM10237
Chapter 11: LPC24XX Ethernet
Transmit flow control is enabled via the ‘TX FLOW CONTROL’ bit in the MAC1
configuration register. If the ‘TX FLOW CONTROL’ bit is zero, then the MAC will not
transmit pause control frames, software must not initiate pause frame transmissions, and
the TxFlowControl bit in the Command register should be zero.
configuration register. If the ‘TX FLOW CONTROL’ bit is zero, then the MAC will not
transmit pause control frames, software must not initiate pause frame transmissions, and
the TxFlowControl bit in the Command register should be zero.
Transmit flow control example
illustrates the transmit flow control.
In this example, a frame is received while transmitting another frame (full duplex.) The
device driver detects that some buffer might overrun and enables the transmit flow control
by programming the PauseTimer and MirrorCounter fields of the FlowControlCounter
register, after which it enables the transmit flow control by setting the TxFlowControl bit in
the Command register.
device driver detects that some buffer might overrun and enables the transmit flow control
by programming the PauseTimer and MirrorCounter fields of the FlowControlCounter
register, after which it enables the transmit flow control by setting the TxFlowControl bit in
the Command register.
As a response to the enabling of the flow control a pause control frame will be sent after
the currently transmitting frame has been transmitted. When the pause frame
transmission completes the internal mirror counter will start counting bit slots; as soon as
the counter reaches the value in the MirrorCounter field another pause frame is
transmitted. While counting the transmit datapath will continue normal transmissions.
the currently transmitting frame has been transmitted. When the pause frame
transmission completes the internal mirror counter will start counting bit slots; as soon as
the counter reaches the value in the MirrorCounter field another pause frame is
transmitted. While counting the transmit datapath will continue normal transmissions.
As soon as software disables transmit flow control a zero pause control frame is
transmitted to resume the receive process.
transmitted to resume the receive process.
9.12 Half-Duplex mode backpressure
When in half-duplex mode, backpressure can be generated to stall receive packets by
sending continuous preamble that basically jams any other transmissions on the Ethernet
medium. When the Ethernet block operates in half duplex mode, asserting
sending continuous preamble that basically jams any other transmissions on the Ethernet
medium. When the Ethernet block operates in half duplex mode, asserting
the TxFlowControl bit in the Command register will result in applying continuous preamble
on the Ethernet wire, effectively blocking traffic from any other Ethernet station on the
same segment.
on the Ethernet wire, effectively blocking traffic from any other Ethernet station on the
same segment.
Fig 32. Transmit Flow Control
MirrorCounter
(1/515 bit
slots)
400
0
150
300
200
450
350
250
50
100
500
PauseTimer
MirrorCounter
TxFlowCtl
clear
TxFlowCtl
pause control
frame
transmission
pause control
frame
transmission
pause control
frame
transmission
normal transimisson
normal receive
normal
transmission
normal receive
(R)MII
receive
(R)MII
transmit
device driver
register
writes
pause in effect