National Instruments cFP-RTD-122 用户手册
FP-RTD-122 and cFP-RTD-122
14
ni.com
CE Compliance
This product meets the essential requirements of applicable
European Directives, as amended for CE Marking, as follows:
European Directives, as amended for CE Marking, as follows:
Low-Voltage Directive (safety)......... 73/23/EEC
Electromagnetic Compatibility
Directive (EMC) ............................... 89/336/EEC
Directive (EMC) ............................... 89/336/EEC
Note
Refer to the Declaration of Conformity (DoC) for
this product for any additional regulatory compliance
information. To obtain the DoC for this product, click
Declarations of Conformity Information at
information. To obtain the DoC for this product, click
Declarations of Conformity Information at
ni.com/hardref.nsf/
.
Mechanical Dimensions
Figure 7 shows the mechanical dimensions of the FP-RTD-122
installed on a terminal base. If you are using the cFP-RTD-122,
refer to the Compact FieldPoint controller user manual for the
dimensions and cabling clearance requirements of the Compact
FieldPoint system.
installed on a terminal base. If you are using the cFP-RTD-122,
refer to the Compact FieldPoint controller user manual for the
dimensions and cabling clearance requirements of the Compact
FieldPoint system.
Figure 7. FP-RTD-122 Mechanical Dimensions
Where to Go for Support
For more information about setting up the FieldPoint system, refer
to these National Instruments documents:
to these National Instruments documents:
•
FieldPoint network module user manual
•
Other FieldPoint I/O module operating instructions
•
FieldPoint terminal base and connector block operating
instructions
instructions
109.5 mm
(4.31 in.)
91.44 mm
(3.60 in.)
107.19 mm
(4.22 in.)