Alcatel Carrier Internetworking Solutions Switch/Router 用户手册

Page 36-16

The 

 command allows the user to tailor diagnostic testing characteristics per slot 

module. To configure diagnostic tests for a switching module, enter the 

 command 

followed by the slot number for the module. The slot number is an integer ranging from 1 to 
the number of slots in the chassis (3 for 3-slot Omni Switch/Routers; 5 for 5-slot Omni 
Switch/Routers and 9 for 9-slot Omni Switch/Routers).

The 

 command allows the user to bypass testing individual slots when running the 

 command. In addition, the 

 command allows the user to configure the port speed 

and port mode for applicable Ethernet modules for tailoring of individual slots during diag-
nostic testing.

No default value is set and input must be provided at the time of entering the command. For 
example, to configure applicable diagnostic tests for the switching module in slot 4, enter:

at the system prompt. The following is a typical example.

Note that for all switching modules other than modules, the 

 option is 

the only available one. See Configuring Tests for Ethernet Modules on page 36-17 for informa-
tion on using the 

 command with Ethernet modules.

. Allows the user to select to bypass this slot when the 

 command 

is issued. The default is 

. If you want the 

 command to skip this module, enter

The following will then be displayed.

Enter 

 if you want to make this change. If you enter 

, the change will be made and 

the following will be displayed.

If you want to cancel this change, enter 

 and the 

 command will terminate and 

the following will be displayed.