Alcatel Carrier Internetworking Solutions Switch/Router 用户手册
Configuring the Diagnostic Test Environment
Page 36-17
Configuring Tests for Ethernet Modules
Tailoring of applicable Ethernet modules includes selection of Port Speeds and of Port Modes.
To configure applicable diagnostic tests for an Ethernet 10/100 switching module in slot 3,
enter:
To configure applicable diagnostic tests for an Ethernet 10/100 switching module in slot 3,
enter:
testcfg 3
The following is a sample display of the test configuration for an Ethernet 10/100 switching
module.
module.
Test Configuration for slot 3
1) Skip this slot during test { No (1),
Yes (2) } : No
2) Port Speed { 10/100 (1),
100
(2),
10
(3) }
: 10/100
3) Port Mode { Full Duplex (1),
Half Duplex (2) }
: Full Duplex
Enter (option=value/save/cancel)
:
To change any of the values above, enter the line number, followed by an equal sign, and
followed by the new value. For example, to change the
followed by the new value. For example, to change the
Port Mode
field to half duplex, enter
3=2
The configurable fields displayed by the
testcfg
command for an Ethernet module are
described below.
Skip this slot during test
. Allows the user to select to bypass this slot when the
test all
command
is issued. The default is
No
.
Port Speed
. Allows the user to select module port speed during the diagnostic port test. Selec-
tion includes
10/100BaseT
,
100BaseT
, or
10BaseT
. The default is
10/100BaseT
, which alternates
the speed of the port test from 10 to 100 on each pass of the port test.
Port Mode
. Allows the user to select module port mode during diagnostic port test. Selection
includes Full Duplex or Half Duplex. The default value is
Full Duplex
.
Enter
save
if you want to make this change. If you want to cancel this change, enter
cancel
and the
testcfg
command will terminate.