Alcatel Carrier Internetworking Solutions Switch/Router 用户手册

Page 9-27

Various services in the switch use the 

HRE-X

 router port 

MAC

 registers. The registers are allo-

cated as the services are loaded at startup. The 

 submenu contains five commands for use 

with the Hardware Routing Engines (

HRE

s). The 

 command allows you to config-

ure the switch so that registers are reserved for particular services. The 

 command 

allows you to view your current configuration. To display the 

 submenu, enter

at the system prompt. A screen similar to the following is displayed.

To view the current 

HRE-X

 configuration enter

at the system prompt. A screen similar to the following is displayed.

The fields displayed by the 

 command are described below:

. The number of the 

MAC

 registers.

. The service type assigned to the register. 

. The service that is actively using the register.

To reserve a register for a particular service, you can assign the registers to the service. To 
assign the registers on the 

HRE-X

 router port, enter

at the system prompt. A screen similar to the following is displayed.

The 

 is either 1, 2 or 3 referring to the 

MAC

 register. The 

 

parameter specifies the service configured to the registers. The service types are shown on the 
screen display are defined here.

 This register is not reserved to a particular service.

 This register is assigned to standard routing.

 This register is assigned to Classical 

IP

 This register is assigned to Channelized DS-3 module (WSX-M013).

 This register is assigned to Multiprotocol Over 

ATM

 This register is assigned to Virtual Router Redundancy Protocol.