Brady 200M-e 300 用户手册

Bradyprinter 200M-e and 200M-e 300 User’s Guide

17

0HGLDDQG5LEERQ&DOLEUDWLRQ

NOTE:  All steps must be performed in the following procedure, 
even if only one sensor needs to be adjusted.

1. Press the SETUP/EXIT key.

2. Press the NEXT/SAVE key until “MEDIA AND RIBBON 

CALIBRATE” displays.

3. To start the calibration procedure, press the (+) key.  “LOAD 

BACKING CANCEL CONTINUE” displays.

4. Open the printhead.  Remove approximately 8" (203 mm) of labels 

from the media roll, enough so that only the backing material is 
threaded between the media sensors when the media is loaded
(refer to Figure 10).