National Instruments 1128 用户手册

For the system to function properly, it must be controlled by a DAQ device or 

NI 4021 switch controller, or be a 2000 Series SCXI chassis.

Run Measurement & Automation Explorer (MAX) to configure and test 
your SCXI-1127/1128. If you need help during the configuration process, 
open the Measurement & Automation Help file by selecting Help»Help 
Topics.

1.

Run MAX by double-clicking the icon on your desktop.

2.

To add a new chassis, right-click Devices and Interfaces and select 
Create New. Select the appropriate chassis from the list box and click 
Finish.

3.

Configure the chassis by selecting the Chassis ID. The chassis ID is an 
arbitrary number that you choose for use by the software to uniquely 
specify the chassis. 

4.

Select the Chassis Address (refer to your SCXI Chassis User Manual 
for further information). 

For the SCXI-2000, you also need to select the Baud Rate and COM 
Port.

You now have the choice of auto-detecting your modules or manually 
adding them depending on your application. If you are using an MIO or 
DIO DAQ device, you can either auto-detect or manually add the modules. 
If you are using a DMM, you must manually add the modules.

If you selected auto-detect and the chassis is not an SCXI-2000 remote 
chassis, you must have your chassis connected to your DAQ device.

1.

Click Next.

2.

Select your communication path, except in the case of the SCXI-2000, 
and click Next.

3.

Select the module cabled to your communication path, except in the 
case of the SCXI-2000, and click Finish.

Your SCXI chassis and SCXI-1127/1128 modules are now configured in 
the software with your modules. To configure the properties for a particular 
module, perform the following steps:

1.

Display the list of Devices and Interfaces by clicking the + next to the 
Devices and Interfaces icon.