Sterling A0567659 用户手册
Page 38 of 118
SGB Batch Blender with Mitsubishi Controller
Verify all clearances on the top and beside the processing
machine. This is to insure that all motors, hoppers, control
panels, etc. have adequate room for proper operation and
servicing.
machine. This is to insure that all motors, hoppers, control
panels, etc. have adequate room for proper operation and
servicing.
Refer to the assembly drawing with the unit for actual height and
width dimensions.
width dimensions.
Note:
Allow at least 36” clearance around blender to provide
adequate room for cleaning, servicing, etc.
adequate room for cleaning, servicing, etc.
Using proper lifting equipment, lift the blender, using the lifting
lugs attached to the top plate of the blender. These lifting lugs
can also be used to fasten horizontal or angled braces to the
blender if more stability is needed.
lugs attached to the top plate of the blender. These lifting lugs
can also be used to fasten horizontal or angled braces to the
blender if more stability is needed.
Take care to insure proper orientation with adequate access to
operator controls, mix chamber, and metering units.
operator controls, mix chamber, and metering units.
Important!
Never weld on the blender, support stand, machine or mezzanine
without first removing the control panel and verifying that the
blender is properly grounded.
without first removing the control panel and verifying that the
blender is properly grounded.