Whirlpool ADG 7952 用户手册

If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem
(* see also the corresponding chapter in the user instructions).

• No water supply.

• Open the tap.

• The appliance does not load 

sufficient water.

• Clean the water supply tap filter.
• Ensure there are no kinks in the water hose.

• There is a power failure.

• Insert the plug into the mains socket.
• Press the Start button.
• Close the door.
• Check the domestic circuit fuse.

• Starting the selected programme.

• The programme can be set to “0” to start.

• Insufficient rinse aid.

• Increase dosage *.

• Residual water in cavities.

• Load crockery at an angle.

• The water jet does not reach 

the crockery.

• Arrange crockery so that items do not touch each 

other.
Load crockery upside down.

• Insufficient detergent.

• Follow recommended detergent dosage.

• Unsuitable programme.

• Select a more intense wash cycle.

• Spray arms blocked.

• The spray arms must be able to turn freely.

• Spray arm nozzles clogged.

• Remove any impurities obstructing the water flow *.

• Incorrect detergent/detergent too old. • Use a good quality detergent.

• Clogged filters.

• Check filters regularly/if necessary clean *.

• Filters incorrectly assembled.

• Insert the filter correctly *.

• Tomato/carrot juice,...

• Depending on the material, if necessary use a 

detergent with a greater whitening power.

• removable

• Streaks on the crockery/glasses.

• Increase the rinse aid dosage *.

• Streaks on glasses.

• Reduce the rinse aid dosage *.

• Layer of salt on crockery/glasses.

• Close the salt container lid properly *.

• not removable

• Insufficient water softening, 

calcium deposits.

• Change water hardness setting, if necessary add

salt *.

• Cannot be washed in the dishwasher.

• Use suitable glasses.

• Not made of stainless steel.

• Use suitable cutlery.

• The START indicator lamp flashes.

• Ensure that the filter assembly is not clogged and

if necessary clean it *.
Start the programme again. Press the Start button for 
2 seconds, until the Start indicator lamp switches 
off. Select a new programme and press the Start 
button again.

• Indicator F... (if provided).

• Call the After-Sales Service.

If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the 
water supply tap, then call our After-Sales Service (see guarantee).

Before contacting our After-Sales Service, take note of the following:

• The nature of the fault.
• The appliance type and model.
• The service code (the number indicated on the adhesive rating 

plate) inside the door on the right-hand side.