InSinkErator AS-101K 用户手册

8

This control center was inspected and tested under 
operating conditions before shipment from the factory. 
In case of trouble, check the items listed below.

 

1.  No incoming line power, turn line power on.

  2.  Electric disconnect switch is not ON. Turn electric 

disconnect to ON position.

  3.  Electrical disconnect switch has been reactivated 

and 30-second delay has not yet expired. Wait 30 

seconds and try starting again.

  4.  Control circuit fuse FNA2 is blown. Replace fuse.

  1.  Control center wired for automatic shut-off. Press  

start button. If disposer runs for 10 minutes then 

shuts off, the automatic shutoff is active.  If the 

manual setting is desired, change as indicated in 

the feature section. 

  2.  Disposer is jammed. Press stop button and  

follow directions for unjamming that were  

supplied with the disposer.

3.  Disposer motor overload protector has tripped.

 

Follow instruction in C1.

1.  Overload protector on the disposer may have  

 

tripped. Press stop button. Locate red reset  

button on front of disposer electrical cover.  

Press to reset. If motor had been running, wait    

five minutes for the motor and overload to cool    

down before starting.

 

2.  Disposer is jammed. Press stop button and  

  follow directions for unjamming that were  

  supplied with the disposer.

 • Allow only trained personnel to operate disposer.
 • Use baffles and guarding to avoid splashing and 

ejection of materials.

 • Do not put fingers or hands into the disposer.
 • When attempting to remove objects from a  

disposer, use long-handled tongs or pliers.

 • Turn power off before clearing a jam, removing  

an object from the disposer or pressing the  

red reset button.

Use only an FNA2 replacement fuse. Using another 

replacement fuse will result in product damage.  

 • Troubleshooting other than what is recommended 

in this section should only be performed by  

qualified service personnel.

 • Further troubleshooting performed by untrained 

personnel could result in electric shock or damage 

to the control center.

 • All electrical checks must be performed by a  

qualified professional.

1.  Water solenoid valve is installed backward.  

  Water flow should be in the direction of the arrow  

  on valve.

1.  Incorrect solenoid valve combination 

connections. See Water Solenoid Valve, page 7.

2.  Incorrect trip point adjustment. See Current 

  Sensing Control Setup, page 8.

3.  Food load is present in disposer.

1.   Insufficient food load is present.

2.   Incorrect trip point. See Current Sensing Control   

  Setup, page 8.

3.  Solenoid valve wiring incorrect in panel.
4.   More than two water solenoids wired into  

 

  system. System should have one solenoid with    

  a 1 GPM flow control and one solenoid with a  

  7 GPM flow control. 

1.   Do not overload disposer with excess amounts of  

  garbage and water (see disposer instructions for   

  recommended water flows).