BTC btop10 快速安装指南
2
1.2 Switch
1. power slide switch
o: power off
I
:
power
on
2. PAIR tact switch:
push this PAIR switch slightly will enable blue tooth PAIRING
function(blue tooth LED will blink quickly)
function(blue tooth LED will blink quickly)
NOTE:
1. Pairing need to be done one time only when user use GPS and
1. Pairing need to be done one time only when user use GPS and
Connect with PDA..etc device first time
2. Unless user have another PDA or Blue tooth enable device for
BTC GPS, other wise user don’t need to push this switch
WARNING:
1. Pairing switch may not be activated by all blue tooth conection
condition, please turn off power first, and then
push slightly Paring switch again if any problem to this issue.
3. DC5V:
plug with car charger or travel charger to charge battery
(input:
DC
5V,
500mA)
WARNING:
1. due to the size of the MMCX RF connector is quite compacted, so please
use BTC external active antenna with MMCX plug, or other external antenna which have
been approved by BTC.
use BTC external active antenna with MMCX plug, or other external antenna which have
been approved by BTC.
2. Quick start
First step:
charging battery more than 5 hours
Before using bluetooth GPS receiver, battery have to be charged first,
Connect travel charger or car charger with GPS receiver DC5V Jack.
Charging the battery until the battery LED from orange color become
Green color.
Before using bluetooth GPS receiver, battery have to be charged first,
Connect travel charger or car charger with GPS receiver DC5V Jack.
Charging the battery until the battery LED from orange color become
Green color.
Second step:
turn on GPS receiver , then wait for blue tooth connection
and position to be fixed
LED will show below status
and position to be fixed
LED will show below status
The GPS LED (green), will be active, and will blink slowly per
second later if position have been fixed
second later if position have been fixed