Roland RS-70 业主指南

 

Connect the RS-70 and the external device as shown in the figure.

 

Use audio cables to connect audio equipment, such as an amp or speakers. If you are 
using headphones, plug them into the PHONES jack. Connect pedal switches or 
expression pedals as necessary.

 

Before turning on the RS-70’s power, check the following:

 

• Are all devices connected properly?
• Are the volume controls of the RS-70 and any other connected equipment 

turned to the minimum position?

• Is the AC adapter correctly connected to the RS-70?

 

Press the power switch on the rear panel of the RS-70 to turn on the power.

 

fig.q01-02

 

Turn on the power of the connected audio devices.

 

Play the RS-70’s keyboard and gradually raise the volume controls of the 
RS-70, or the connected audio equipment to an appropriate volume level.

 

fig.q01-03

If you want to know how to make the connections with another external device, refer 
to:
Using the RS-70 to play an external MIDI sound module

Once the connections have 
been completed (p. 17), 
turn on power to your 
various devices in the order 
specified. By turning on 
devices in the wrong order, 
you risk causing 
malfunction and/or 
damage to speakers and 
other devices.

Turn up the RS-70’s 
volume level carefully. 
Excessive volume can 
damage connected audio 
devices, your hearing, or 
annoy your neighbors.

This unit is equipped with 
a protection circuit. A brief 
interval (a few seconds) 
after power up is required 
before the unit will operate 
normally.

RS-70_e4.book 18 ページ ２００３年８月１８日　月曜日　午前９時４７分