Roland RS-70 业主指南
19
Getting ready
Turning off the power
1.
Before you turn off the power, make sure of the following points.
• Are the volume controls of the RS-70 and the other connected equipment
turned to the minimum position?
2.
Turn off the power for all connected audio devices.
3.
Turn off the RS-70’s power switch.
Adjusting the display contrast
(LCD CONTRAST)
The characters in the display may be difficult to view immediately after turning on
the power or after extended use; this may also be because of where and how the
display is situated. Follow the steps below to adjust the display’s contrast.
the power or after extended use; this may also be because of where and how the
display is situated. Follow the steps below to adjust the display’s contrast.
fig.q01-04
1.
Press [SYSTEM] so it is lit.
2.
Use PAGE/CURSOR [
]/[
] to select “LCD Contrast.”
fig.q01-05
3.
Use VALUE [-]/[+] to set the value (1–10).
2
3
1
The LCD CONTRAST
setting is saved
automatically, and is
retained even while the
power is off.
setting is saved
automatically, and is
retained even while the
power is off.
RS-70_e4.book 19 ページ ２００３年８月１８日 月曜日 午前９時４７分