Roland RS-70 业主指南
20
Reset to default factory settings (Factory Reset)
This restores all data in the RS-70 to the factory-set condition (
Factory Reset
).
fig.q02-01
1.
Press [PATCH] so it is lit and you are in Patch mode.
2.
Press [UTILITY] so it is lit.
3.
Use PAGE/CURSOR [
]/[
] to select “5:FACTORY RESET.”
fig.q02-02_40
4.
Press [ENTER].
fig.q02-03_40
5.
Press [ENTER] again to execute the Factory Reset.
When the display indicates “COMPLETED,” the factory reset operation has been
completed.
completed.
If there is important data
you’ve created that’s stored
in the RS-70’s internal
memory, you must note
that all such data will be
discarded when a Factory
Reset is performed. If you
want to keep the existing
data, save it on a disk (p.
120).
you’ve created that’s stored
in the RS-70’s internal
memory, you must note
that all such data will be
discarded when a Factory
Reset is performed. If you
want to keep the existing
data, save it on a disk (p.
120).
3
1
2
4, 5
Be sure not to turn off the power while Factory Reset is being performed.
If the power is turned off or interrupted while Factory Reset is being
performed, the internal data may become corrupted.
If the power is turned off or interrupted while Factory Reset is being
performed, the internal data may become corrupted.
The Factory Reset operation will require several minutes.
Press [EXIT] to cancel the
factory reset.
factory reset.
Factory Reset can be
executed not only from
Patch mode, but also from
the Utility functions of
Pattern mode or Song
mode (p. 90, p. 118).
executed not only from
Patch mode, but also from
the Utility functions of
Pattern mode or Song
mode (p. 90, p. 118).
RS-70_e4.book 20 ページ 2003年8月18日 月曜日 午前9時47分