Roland SH-201 补充手册

SH-201 MIDI Implementation

●

Pitch Bend Change

Status

2nd byte

3rd byte

EnH

llH

mmH

n = MIDI channel number:

0H - FH (ch.1 - 16)

mm, ll = Pitch Bend value:

00 00H - 40 00H - 7F 7FH (-8192 - 0 - +8191)

■

System Realtime Messages

●

Active Sensing

Status
FEH

This message is transmitted at intervals of approximately 250 msec.

This message is not sent when ACTIVE SENSING TRANSMIT SWITCH parameter
(SYSTEM COMMON MIDI) is OFF.

■

System Exclusive Messages

Universal Non-realtime System Exclusive Message and Data Set 1 (DT1) are the only
System Exclusive messages transmitted by the SH-201.

●

Universal Non-realtime System Exclusive Message

❍

Identity Reply Message

Receiving Identity Request Message, the SH-201 send this message.

Status

Data byte

Status

F0H

7EH, dev, 06H, 02H, 41H, 16H, 02H,

F7H

00H, 00H, 00H, 03H, 00H, 00H

Byte

Explanation

F0H

Exclusive status

7EH

ID number (Universal Non-realtime Message)

dev

Device ID (dev: 10H - 1FH)

06H

Sub ID#1 (General Information)

02H

Sub ID#2 (Identity Reply)

41H

ID number (Roland)

16H 02H

Device family code

00H 00H

Device family number code

00H 03H 00H 00H

Software revision level

F7H

EOX (End of Exclusive)

●

Data Transmission

❍

Data set 1 DT1 (12H)

Status

Data byte

Status

F0H

41H, dev, 00H, 00H, 16H, 12H, aaH, bbH,

F7H

ccH, ddH, eeH, ... ffH, sum

Byte

Explanation

F0H

Exclusive status

41H

ID number (Roland)

dev

Device ID (dev: 00H - 1FH, 7FH)

00H

Model ID #1 (SH-201)

00H

Model ID #2 (SH-201)

16H

Model ID #3 (SH-201)

12H

Command ID (DT1)

aaH

Address MSB: upper byte of the starting address of the data to be sent

bbH

Address: upper middle byte of the starting address of the data to be sent

ccH

Address: lower middle byte of the starting address of the data to be sent

ddH

Address LSB: lower byte of the starting address of the data to be sent.

eeH

Data: the actual data to be sent. Multiple bytes of data are transmitted in
order starting from the address.

ffH

Data

sum

Checksum

F7H

EOX (End Of Exclusive)

The amount of data that can be transmitted at one time depends on the type of data, and
data will be transmitted from the specified starting address and size. Refer to the address
and size given in “Parameter Address Map” (p. 4).

Data larger than 256 bytes will be divided into packets of 256 bytes or less, and each
packet will be sent at an interval of about 20 ms.

3. Parameter Address Map

Transmission of “#” marked address is diviedd to some packets. For example, ABH in
hexadecimal notation will be divied to 0AH and 0BH, and is sent/received in this order.

■

SH-201 (ModelID = 00H 00H 16H)

+——————————————————————————————————————————————————————————————————————————————+
| Start | |
| Address | Description |
|—————————————+————————————————————————————————————————————————————————————————|
| 01 00 00 00 | System |
|—————————————+————————————————————————————————————————————————————————————————|
| 10 00 00 00 | Temporary Patch |
|—————————————+————————————————————————————————————————————————————————————————|
| 20 00 00 00 | User Patch (001) |
| 20 01 00 00 | User Patch (002) |
| : | |
| 20 1F 00 00 | User Patch (032) |
+——————————————————————————————————————————————————————————————————————————————+

❍

System

+——————————————————————————————————————————————————————————————————————————————+
| Offset | |
| Address | Description |
|—————————————+————————————————————————————————————————————————————————————————|
| 00 00 00 | System Common |
+——————————————————————————————————————————————————————————————————————————————+

❍

Temporary Patch

+——————————————————————————————————————————————————————————————————————————————+
| Offset | |
| Address | Description |
|—————————————+————————————————————————————————————————————————————————————————|
| 00 00 00 | Temporary Patch |
+——————————————————————————————————————————————————————————————————————————————+

❍

Patch

+——————————————————————————————————————————————————————————————————————————————+
| Offset | |
| Address | Description |
|—————————————+————————————————————————————————————————————————————————————————|
| 00 00 00 | Patch Common |
| 00 01 00 | Patch Tone (1:Upper) |
| 00 02 00 | Patch Tone (2:Lower) |
| 00 03 00 | Patch Delay |
| 00 04 00 | Patch Reverb |
| 00 05 00 | Patch Arpeggio Common |
| 00 06 00 | Patch Arpeggio Pattern (Note 1) |
| 00 07 00 | Patch Arpeggio Pattern (Note 2) |
| : | |
| 00 15 00 | Patch Arpeggio Pattern (Note 16) |
+——————————————————————————————————————————————————————————————————————————————+

❍

System Common

+——————————————————————————————————————————————————————————————————————————————+
| Offset | |
| Address | Description |
|—————————————+————————————————————————————————————————————————————————————————|
| 00 00 | 0aaa aaaa | Patch Bank Select MSB (CC# 0) (0 — 127) |
| 00 01 | 0aaa aaaa | Patch Bank Select LSB (CC# 32) (0 — 127) |
| 00 02 | 0aaa aaaa | Patch Program Number (PC) (0 — 127) |
| 00 03 | 0000 aaaa | Patch Rx/Tx Channel (0 — 15) |
| | | 1 — 16 |
| 00 04 | 0000 000a | Patch Remain (0 — 1) |
| | | OFF, ON |
|—————————————+———————————+————————————————————————————————————————————————————|
|# 00 05 | 0000 aaaa | |
| | 0000 bbbb | |
| | 0000 cccc | |
| | 0000 dddd | Master Tune (24 — 2024) |
| | | —100.0 — 100.0 [cent] |
| 00 09 | 00aa aaaa | Master Key Shift (40 — 88) |
| | | —24 — +24 |
| 00 0A | 0aaa aaaa | Master Level (0 — 127) |
|—————————————+———————————+————————————————————————————————————————————————————|
| 00 0B | 0000 00aa | System Clock Source (0 — 3) |
| | | PATCH, SYSTEM, MIDI, USB |
|# 00 0C | 0000 aaaa | |
| | 0000 bbbb | |
| | 0000 cccc | System Tempo (5 — 300) |
| | | 5 — 300 [BPM] |
| 00 0F | 0000 000a | Receive Program Change (0 — 1) |
| | | OFF, ON |
| 00 10 | 0000 000a | Receive Bank Select (0 — 1) |
| | | OFF, ON |
| 00 11 | 0000 000a | Transmit Edit Data (0 — 1) |
| | | OFF, ON |
| 00 12 | 0000 000a | Soft Through (0 — 1) |
| | | OFF, ON |
| 00 13 | 0000 000a | MIDI—USB Thru (0 — 1) |
| | | OFF, ON |
|—————————————+———————————+————————————————————————————————————————————————————|
| 00 14 | 0000 000a | Transmit Program Change (0 — 1) |
| | | OFF, ON |
| 00 15 | 0000 000a | Transmit Bank Select (0 — 1) |
| | | OFF, ON |
| 00 16 | 0000 000a | Transmit Active Sensing (0 — 1) |
| | | OFF, ON |
|—————————————+———————————+————————————————————————————————————————————————————|
| 00 17 | 0000 0aaa | Octave Shift (61 — 67) |
| | | —3 — +3 |
| 00 18 | 0000 aaaa | Transpose Value (59 — 70) |
| | | —5 — +6 |
| 00 19 | 0000 000a | Local Switch (0 — 1) |
| | | OFF, ON |
| 00 1A | 0000 000a | Remote Keyboard Switch (0 — 1) |
| | | OFF, ON |
|—————————————+———————————+————————————————————————————————————————————————————|
| 00 1B | 0000 000a | Pedal Polarity (0 — 1) |
| | | STANDARD, REVERSE |
| 00 1C | 0000 0aaa | Pedal Assign (0 — 7) |
| | | HOLD, MODULATION, VOLUME, |
| | | BALANCE, PAN, EXPRESSION, |
| | | START/STOP, ARP—SW |
|—————————————+———————————+————————————————————————————————————————————————————|
| 00 1D | 0000 aaaa | D Beam Sens (1 — 8) |
|—————————————+———————————+————————————————————————————————————————————————————|
| 00 1E | 0000 000a | Recorder Sync Output (0 — 1) |
| | | OFF, ON |
| 00 1F | 0000 0aaa | Recorder Metronome Mode (0 — 3) |
| | | OFF, REC—ONLY, REC&PLAY, ALWAYS |
| 00 20 | 0000 0aaa | Recorder Metronome Level (0 — 7) |
|—————————————+————————————————————————————————————————————————————————————————|
| 00 00 00 21 | Total Size |
+——————————————————————————————————————————————————————————————————————————————+