Roland v-synth xt 业主指南

下载
页码 212
 
127
 
Settings Common to All Modes (System Mode)
 
Settings Common to All Modes (System Mode)
USB Audio Input Source
 
When the V-Synth XT is connected via USB to your computer, this 
specifies the source of the USB audio that will be output to the 
computer.
 
Value:
 
 OFF, MAIN, ANALOG
 
USB Audio Input Monitor Sw
 
Specifies whether USB Audio Input Source monitoring will be sent 
from the V-Synth XT's MAIN OUT (ON) or will not be sent (OFF).
 
Value:
 
 ON, OFF
 
USB Audio Output Dest
 
When the V-Synth XT is connected via USB to your computer, this 
specifies the output destination of the USB audio that is received 
from the computer.
 
Value:
 
 OFF, MAIN, DIR
 
Controller Settings (Controller)
 
Tx
 
fig.05-05_50
 
Patch Tx Ch (Patch Transmit Channel)
 
Specifies the transmit channel of MIDI messages in Patch mode. If 
you do not want to transmit MIDI messages to external MIDI 
devices, turn this parameter “OFF.” If you want the transmit channel 
to always match the Patch Receive Channel, set this parameter to 
“RX CH.”
 
Value:
 
 1–16, RX CH, OFF
 
Tx PC (Transmit Program Change Switch)
 
Specifies whether Program Change messages will be transmitted 
(ON) or not (OFF).
 
Value:
 
 OFF, ON
 
Tx Bank (Transmit Bank Select Switch)
 
Specifies whether Bank Select messages will be transmitted (ON) or 
not (OFF).
 
Value:
 
 OFF, ON
 
Tx Active Sens (Transmit Active Sensing 
Switch)
 
Specifies whether Active Sensing messages will be transmitted (ON) 
or not (OFF).
 
Value:
 
 OFF, ON
INPUT
Jack
MIC
Jack
DIRECT
OUT
OFF
ANALOG
MAIN
DIR
MAIN
V-Synth XT
USB Audio OUT
USB Audio IN
USB A
udio Output Dest
USB A
udio Input Source
MAIN
OUT
INPUT
Monitor
Switch
Sound Generator
V-SYNTH_XT_e2 127 ページ 2005年3月23日 水曜日 午後4時39分