Zhone 5216 用户手册

97-15304

6-Pin

RJ11 Plug

DSL   L in e

Pin #1

Pin #6

DSL and Ethernet
LEDs are on and
there is no data
transmission.

The DSL link and the Ethernet link have been established. If
the problem continues, contact the NSP.

Ethernet LED is off.

Verify that the Ethernet 10BaseT cable is securely installed at
both ends, and that a PC is connected and powered on.

Verify that the correct crossover cable is installed. Refer to

PWR LED is off.

Check that the power cord is securely installed on both ends.

If no LEDs are on, the power supply may be defective. Try a
different outlet to test the power supply. If problem persists,
contact the NSP.

If other LEDs are on, the PWR light may be burned out. Unplug
the unit and reapply power; watch all LEDs during the
power-on self-test to verify that the PWR LED is functioning.

TST LED is on.

A test initiated by the NSP may be active. Wait five minutes. If
the TST LED does not go off, contact the NSP.

Obtain standard twisted-pair CAT3 or better cables.

H

The DSL interface connector uses a 6-pin, non-keyed modular plug.

1 & 2

Not used

3

DSL Ring

4

DSL Tip

5 & 6

Not used