Zhone 2208 用户指南
C o n f i g u r a t i o n
4-5
Figure 4.3
JetFusion 2208 WAN Configuration Menu (ATM)
NOTICE:
The options displayed on the WAN Configuration menu above are the
options you will see if ATM is the configured Datalink Protocol (refer to
“Configure Datalink Protocol” below).
options you will see if ATM is the configured Datalink Protocol (refer to
“Configure Datalink Protocol” below).
NOTICE:
You must sign on as Supervisor to configure the WAN interface. Be sure
to reset the IAD when you have finished making changes to WAN
settings. Resetting the IAD causes the configuration changes to take
effect.
to reset the IAD when you have finished making changes to WAN
settings. Resetting the IAD causes the configuration changes to take
effect.
Figure 4.4
WAN Configuration Menu (Frame Relay)
Although you must reset the IAD when you have completed WAN
configuration, you may configure all WAN configuration (i.e., each numbered
option) before resetting the IAD.
configuration, you may configure all WAN configuration (i.e., each numbered
option) before resetting the IAD.
Configure Physical Interface
− SDSL Interface (2308
Only)
The tasks described in this section all begin on the SDSL Configuration menu
(Figure 4.5). You should review and update each of these options as
necessary, and always reset the IAD when you finish SDSL configuration.
To configure the SDSL interface, Type “2” (Configure Physical Interface) on
(Figure 4.5). You should review and update each of these options as
necessary, and always reset the IAD when you finish SDSL configuration.
To configure the SDSL interface, Type “2” (Configure Physical Interface) on
the WAN Configuration menu to display the SDSL Configuration menu.