LXE hx3 参考指南
20
Assembly
HX3 Reference Guide
E-EQ-HX3RG-C
6. Press the hook and loop fabric at the top of the device together.
7. The HX3 in the Voice Case is ready for use.
8. Put the belt on. Adjust the belt and voice case for comfort.
Examine the tethers and the hook and loop fabric fastening periodically. If any are loose or
unfastened, tighten the tethers and the top fastener before placing the voice case back into service.
If the voice case is damaged, it should be removed from service.
unfastened, tighten the tethers and the top fastener before placing the voice case back into service.
If the voice case is damaged, it should be removed from service.
Note:
The HX3 with a voice case does not fit in the cradle. Remove the voice case before
placing the HX3 in a charged cradle.
placing the HX3 in a charged cradle.
Connecting the Audio Cable and a Headset
See section titled Set the Audio Speaker Volume.
Note:
The audio option draws power from the tethered battery. The mobile device internal
speaker and internal microphone are disabled when a headset and microphone is
connected.
speaker and internal microphone are disabled when a headset and microphone is
connected.
The headset consists of an earpiece, a microphone and an attached cable. The headset attaches to
the audio/battery cable which attaches to the HX3. The mobile device internal speaker is disabled
when a headset is connected.
the audio/battery cable which attaches to the HX3. The mobile device internal speaker is disabled
when a headset is connected.
Figure 1-22 Audio/Battery Cable and Headset
1 Align the audio connector and the headset quick connect cable end. Firmly push the cable
ends together until they click and lock in place.
2 Snap the battery plug into the battery cable connector at the top of the battery.
3 Press the battery/audio connector into either left or right connector on the back of the HX3.
The retaining clip will snap into place and secure the cable connection. Place the cable in the
cable groove.
cable groove.