LXE hx3 参考指南
Tapping the Power Key
21
E-EQ-HX3RG-C
HX3 Reference Guide
Adjust Microphone and Secure the Cable
Do not twist the microphone boom when adjusting the microphone. The microphone should be
adjusted to be about two finger widths from your mouth.
adjusted to be about two finger widths from your mouth.
Make sure the microphone is pointed at your mouth. Note the small “Talk” label near the
mouthpiece. Make sure the Talk label is in front of your mouth. The microphone cable can be
routed over or under clothing.
mouthpiece. Make sure the Talk label is in front of your mouth. The microphone cable can be
routed over or under clothing.
Under Clothing
• Leave the cable exposed only at the top of the collar.
• Be sure to leave a small loop of cable to allow movement of your head.
• Be sure to leave a small loop of cable to allow movement of your head.
Over Clothing
• Use clothing clips to hold the cable close to your body.
• Tuck the cable under the belt, but leave a small loop where it goes under the belt.
• Do not wear the cable on the front of your body. It may get in your way or get
• Tuck the cable under the belt, but leave a small loop where it goes under the belt.
• Do not wear the cable on the front of your body. It may get in your way or get
caught on protruding objects.
Tapping the Power Key
The Power key is an oval button located below the LEDs.
When a battery is connected to the HX3 for the first time press the Power key. The mobile device
begins the startup process. And the Status LED is solid green. Wait until the LED begins blinking
green to indicate the HX3 has successfully booted into the OS.
begins the startup process. And the Status LED is solid green. Wait until the LED begins blinking
green to indicate the HX3 has successfully booted into the OS.
Suspend/Resume Mode -- At other times, tapping the Power key places the HX3 immediately in
Suspend Mode. Tapping the Power key again immediately returns the HX3 from Suspend.
Suspend Mode. Tapping the Power key again immediately returns the HX3 from Suspend.
Note:
Placing the HX3 in suspend terminates the ActiveSync connection, if one is established.
The ActiveSync connection must be re-established after the HX3 exits suspend.
The ActiveSync connection must be re-established after the HX3 exits suspend.