Nortel 5380 发行公告
Hardware Release Notes for the Model 5380 Ethernet and the Model 5580 Token Ring Routers
6
112772-A
Net Module Installation and Removal Warning
Make sure that the pins on the net module plug connector and the pins on the
router baseboard connector are aligned (see
router baseboard connector are aligned (see
). When you push the net
module into the baseboard connector, it should attach easily. If there is any
resistance, STOP and recheck the pins before forcing the connector down.
Refer to the
resistance, STOP and recheck the pins before forcing the connector down.
Refer to the
Quick Installation and Reference for System 5000 Net Modules
(Bay Networks part number 112769-A) for more information.
Figure 1. Properly installing a net module
When you remove a net module from a Model 5380 Ethernet Router or Model
5580 Token Ring Router, you must lift the module straight up, parallel to the
baseboard. Grasp the board close to the connector using both hands; do not pull
the board up from one end. If you rock the module back and forth or side to
side, you can bend the connector pins. When you attempt to reinstall a net
module with bent connector pins, you can damage the net module and the
baseboard.
5580 Token Ring Router, you must lift the module straight up, parallel to the
baseboard. Grasp the board close to the connector using both hands; do not pull
the board up from one end. If you rock the module back and forth or side to
side, you can bend the connector pins. When you attempt to reinstall a net
module with bent connector pins, you can damage the net module and the
baseboard.
WARNING:
If the connectors are not properly aligned, you can bend the
pins, damage the net module and the baseboard, and cause a short circuit.
6703
Plug
Slot
112772-ABook Page 6 Tuesday, December 17, 1996 6:54 AM