Lowrance lcx-112c 操作指南

 

19

7. Make a test run to determine the results. If the bottom is lost at 

high speed, or if noise appears on the display, try sliding the 
transducer bracket down. This puts the transducer deeper into the 

water, hopefully, below the turbulence causing the noise. Be careful 
not to install the transducer bracket below the bottom of the hull! 

TROLLING MOTOR BRACKET INSTALLATION 
(single-frequency only) 
1. Attach the optional TMB-S bracket to the transducer as shown in the 

following figure, using the hardware supplied with the transducer. 

(Note: The internal tooth washer is supplied with the TMB-S.) 

 

2. Slide the adjustable strap supplied with the TMB-S through the slot 

in the transducer bracket and wrap it around the trolling motor. 

Position the transducer to aim straight down when the motor is in 

the water. Tighten the strap securely. 

3. Route the transducer cable alongside the trolling motor shaft. Use 

plastic ties (not included) to attach the transducer cable to the 

trolling motor shaft. Make sure there is enough slack in the cable for 
the motor to turn freely. Route the cable to the sonar unit and the 

transducer is ready for use.