LiteOn dd-500g 用户指南

Some TV channels send out special time signals during 

broadcast, which this DVD recorder can receive and use 

to  automatically  update  the  system  clock.  Follow  the 

steps listed below to activate this function. If the cable 

TV channels in your area do not carry the signals, please 

adjust the system clock manually via Setup Date/Time 



Date and Setup Date/Time Time. 

1.    Press SETUP to display the Setup menu.
 2.    Go to ‘Auto Clock’ through Date/TimeAuto Clock.

 3.    Select ‘On’ to activate or ‘Off’ to disable the function, 

then press ENTER.

 4.    If you choose to activate the function, a pop-up 

window showing the time zone option will appear. 

Select a time zone appropriate to the area where you 

are situated, then press ENTER.

 5.    A pop-up window titled ‘Daylight Saving’ will then 

appear. Press  to make selection suitable for your 

time zone, then press ENTER.

 6.    If  you select ‘Auto’ or ‘On’, a pop-up window will 

appear. See step 7 and 8 if you select ‘Full Auto Scan’. 

See step 9 to step 11 if you select ‘Manual Scan’.

 7.    If you select ‘Full Auto Scan’, the DVD recorder will 

start scanning the clock signal submitted by the first 

detected channel.

Started_SystemSetup_04_06

(One minute for each 

channel)

CH 12

 8.    If the scanning is successful, a pop-up window show-

ing current time will appear. Select ‘OK’ to accept or 

‘Cancel’ to discard the setting, then press ENTER. Or 

you can select ‘Scan Next’ to scan next channel.

Started_SystemSetup_04_05

CH 12

 9.    If you select ‘Manual Scan’, a pop-up window will 

appear. Enter the number of channel you would like to 

scan, and press ENTER. Scanning will then start.

Started_SystemSetup_04_06

Manual Scan

Started_SystemSetup_04_05

Scanning...

(max: 1 minute)

CH 12