Canon DP-V2410 手册

84

Error Messages

Message

Description and Action

Hardware error

Backlight error.

Disconnect the power cord, reconnect it, and then
turn on the power.
If the message persists, contact Canon Customer
Center.

Fan error.

Panel error.

I/F error.

System error.

Invalid operation due to high temperature.

The temperature inside the main unit is high. Turn off
the power and wait until the fan stops.

Input signal

No Signal

Displayed when there is no video signal input.

Unsupported

Unsupported video signal is input. Check the
supported signal format (

"Input Configuration" is different from Payload.

Check the "Input Configuration" (

43) and "Signal

Information" (

65) settings. Reset any incorrect

"Input Configuration" settings.

Operation

Invalid operation.

Operation is disabled. Check the setting items.

"Protect Settings" is on.

To use the OSD menu, move the selection frame
to "Protect Settings" and press the jog dial for
approximately 3 seconds.

"CDL Bypass" is on.

When "CDL Bypass" is turned "On", you cannot
adjust "Power", "Saturation", "Offset", or "Slope".

Invalid Password.

Enter the correct password.

USB memory

USB memory is not connected.

Correctly connect the USB memory to the USB port
of this main unit.

Unsupported USB memory.

Check the USB memory format and make sure it is
not protected.

DC power supply

Low Voltage.

Indicates that the input voltage of the DC power
supply has become below approx. 22.5 V. Check the
voltage of the DC power supply.

Low Voltage, Turn off power.

Indicates that the input voltage of the DC power
supply has become below approx. 21.0 V and the
power will be turned off. Connect a 23.5 V or higher
DC power supply and press the   button to turn on
the power.

Invalid Voltage, Turn off power.

Indicates that the input voltage of the DC power
supply has reached approx. 35.8 V or higher. Check
the input voltage of the DC power supply.