Xerox Phaser 300X 安装指南
6
Correcting Printed Colors
6-10
Phaser 300X Color Printer
Selecting color corrections with a printer switch
You can use the printer’s rear panel switches in different ways to set default
color corrections. A change to a switch setting takes effect immediately at
the start of the next job (not during a job); there is no need to reset the
printer.
color corrections. A change to a switch setting takes effect immediately at
the start of the next job (not during a job); there is no need to reset the
printer.
Note
If you use these switches, refer to page 9-29 for details on how
these switches interact with the driver’s color correction
settings.
these switches interact with the driver’s color correction
settings.
Use the printer’s rear panel DIP Switches 8 and 9 to make the selections
outlined in the following table:
outlined in the following table:
Using the switches with a utility file
Place both Switches 8 and 9 in the up position then send a utility file to the
printer to set a user-defined color correction. Refer to the above table for a
list of available corrections.
printer to set a user-defined color correction. Refer to the above table for a
list of available corrections.
To select this color correction:
Place the printer’s rear
panel switches in
these positions:
these positions:
Turn off all color corrections
Switch 8
down and
Switch 9
down
Use Vivid Color (print a truer blue)
Switch 8
up and
Switch 9
down
More closely match printing press colors
(SWOP Press)
(SWOP Press)
Switch 9
up and
Switch 8
down
Use any color correction utility file that has
been downloaded to the printer
been downloaded to the printer
(Euroscale Press is the factory default
selection if no utility file has ever been
downloaded to the printer.)
selection if no utility file has ever been
downloaded to the printer.)
Switch 8
up and
Switch 9
up