Xerox DocuColor 12 Printer with Fiery EX12 安装指南
1
1-11
Connecting network cable to the Fiery
Ethernet connection
For Ethernet connections, the Fiery supports Unshielded Twisted Pair (UTP) cabling,
defined as Category 5 for use with 100BaseT; or as Category 3, Category 4, or
Category 5 for use with 10BaseT. The cable uses an 8-pin RJ-45 connector that plugs
into the RJ-45 socket on the Fiery.
defined as Category 5 for use with 100BaseT; or as Category 3, Category 4, or
Category 5 for use with 10BaseT. The cable uses an 8-pin RJ-45 connector that plugs
into the RJ-45 socket on the Fiery.
N
OTE
:
The 100BaseT type supported by the Fiery is 100BaseTX, also known as Fast
Ethernet. If an Ethernet hub is used, it must be a 100BaseTX hub. The term
“100BaseT” is used to refer to 100BaseTX.
“100BaseT” is used to refer to 100BaseTX.
T
O
CONNECT
TO
THE
E
THERNET
BOARD
•
Connect the network cable to the RJ-45 connector on the back of the Fiery.
You must use a Category 5 unshielded twisted pair cable network cable for 100BaseT.
Token Ring connection
For Token Ring connections, the Fiery supports Unshielded Twisted Pair (UTP)
cabling with an RJ-45 connector and Shielded Twisted Pair (STP) with a DB-9
connector.
cabling with an RJ-45 connector and Shielded Twisted Pair (STP) with a DB-9
connector.
If the Token Ring option is installed, you cannot enable both Ethernet and Token Ring
simultaneously. For more information, see
simultaneously. For more information, see
.
T
O
CONNECT
TO
THE
T
OKEN
R
ING
BOARD
•
Connect the network cable to the proper connector on the back of the Fiery.