Autostart as-1414 用户手册

AS-1414/AS-1424 User Guide 

P. 3

Press the 

 button for approx. 1 second. The parking lights will come 

, informing 

you that the unit has received your signal. Approx. 5 seconds later, the engine will start. The 
parking lights will remain 

 during the pre-programmed run time. 

If the vehicle doesn’t start the first time, the system will shut down, wait a few seconds, and 
try to start the engine again. It will try to start the engine 3 times before giving up. 

Vehicle Presets 

Heater and Heated Seat 
When leaving the vehicle it is recommended to preset the accessory controls in preparation 
for the next remote start.  Settings for the blower motor (fan), front and rear, as well as 
heated seats (if equipped) should not be left on 

.  It is recommended to leave the settings 

on

 or 

 instead. 

Windshield Wipers, Radio and Headlights 
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to 
become energized while running under remote start.  When leaving the vehicle you must 
ensure that the windshield wiper and headlight switches are 

.  Leaving the headlight 

switch

 on certain types of vehicles could cause them to remain 

 even after the remote 

starter shuts down, resulting in a dead battery. 

Driving Off 

With the vehicle running under remote control, press the 

 button to 

 and 

the doors (if installed). Enter the vehicle and do the following: 

x

Turn the ignition key to the 

 position. 

x

Press the brakes to disengage the remote starter unit. 

You are now ready to drive off. 

Caution: do not turn the key to the 

 position with the engine running. This will cause 

the starter motor to re-engage, unless your vehicle is equipped with the Start Kill / Anti-
Grind Feature (Optional). 

Idle Mode 

This feature allows the user to engage the remote starter to take over the vehicle while it is 
already running with the key in the 

switch. The vehicle will keep running for the pre-

programmed run time, or until it is shut down by remote. 

Caution: Do not leave children or pets unattended in a car running in Idle Mode. 

To activate Idle Mode: 
To enable Idle Mode, press and hold the 

,

 or 

 button on your remote 

transmitter while the engine is running.  

Note:  When enabling Idle Mode, pressing 

 or 

will automatically unlock the 

doors.

The parking lights will come 

. Remove the key, exit the vehicle and lock the doors (if 

desired). The engine will continue running and will turn itself 

 when the pre-programmed 

run time expires. 

Ignition Valet 

The system can be placed in Valet Mode to disable the remote starting capabilities. If the 
vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine 
from being accidentally started by remote control.