National Instruments cFP-PWM-520 用户手册

The FP-PWM-520 mounts on a FieldPoint terminal base 
(FP-TB-x), which provides operating power to the module. 
Installing the FP-PWM-520 onto a powered terminal base does 
not disrupt the operation of the bank.

To install the FP-PWM-520, refer to Figure 1 and complete the 
following steps:

1. Slide the terminal base key to either position X, used for any 

module, or position 4, used for the FP-PWM-520 module.

2. Align the FP-PWM-520 alignment slots with the guide rails on 

the terminal base.

3. Press firmly to seat the FP-PWM-520 on the terminal base. 

When the module is firmly seated, the terminal base latch locks 
it into place.

Figure 1.  Installing the FP-PWM-520

1

I/O Module

2

Terminal Base

3

Alignment Slot

4

Terminal Base Key

5

Latch

6

Guide Rails

1

3

2

4

5

6