brocade-communications-sy rfs6000 用户手册
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
13
53-1001931-01
About This Document
In this chapter
•
•
•
•
•
Audience
This document is designed for system administrators with a working knowledge of Layer 2 and
Layer 3 switching and routing.
Layer 3 switching and routing.
If you are using a Brocade Layer 3 router, you should be familiar with the following protocols if
applicable to your network – IP, RIP, OSPF, BGP, ISIS, IGMP, PIM, DVMRP, and VRRP.
applicable to your network – IP, RIP, OSPF, BGP, ISIS, IGMP, PIM, DVMRP, and VRRP.
To avoid confusion among Mobility RFS4000 Controller, Mobility RFS6000 Controller and Mobility
RFS7000 Controller CLI users, generic examples are used throughout this guide. These examples
are relevant to each controller.
RFS7000 Controller CLI users, generic examples are used throughout this guide. These examples
are relevant to each controller.
Example
RFController>cluster-cli enable
RFController>
The syntax, parameters and descriptions within this guide can also be used generically for a
Mobility RFS4000 Controller, Mobility RFS6000 Controller and Mobility RFS7000 Controller.
However, some subtle differences do exist amongst these baselines. These differences are
strongly noted within the specific commands impacted. When these differences are noted, the
options available to each controller baseline are described in detail.
Mobility RFS4000 Controller, Mobility RFS6000 Controller and Mobility RFS7000 Controller.
However, some subtle differences do exist amongst these baselines. These differences are
strongly noted within the specific commands impacted. When these differences are noted, the
options available to each controller baseline are described in detail.