Konica Minolta bizhub 164 用户手册

11-6

bizhub 164

Cannot print according to the 
settings you have configured.

The settings may not be config-
ured correctly.

Check the setting of each item of 
the printer driver.

The selected functions can be 
combined in the printer driver, 
but may not be combined in this 
machine.

The paper size or paper orienta-
tion specified in the application 
may take precedence over the 
settings in the printer driver when 
printing.

Configure settings in the applica-
tion correctly.

Combination fails; pages are not 
combined, but are printed sepa-
rately.

Originals having different orien-
tations are combined.

Align the orientations of the orig-
inal.

Images are not printed properly.

Memory of the computer may be 
insufficient.

Simplify the images to reduce 
the data size.

Paper is not fed from the speci-
fied paper source.

Paper will not be fed from the 
specified paper source if that pa-
per source is loaded with paper 
of a different size or orientation.

Load the paper of the appropri-
ate size and orientation into the 
desired paper source.

A message saying "Scanner not 
ready" appears on the computer 
screen.

The machine has not started up.

Turn off the machine, then check 
that the USB cable is correctly 
connected.
After checking the USB cable, 
turn on the machine again.

A system crash may have oc-
curred on the computer or the 
machine during transmission.

The USB cable was not correctly 
connected during transmission.

A message saying "Scanner 
Busy" appears on the computer 
screen.

If a TWAIN scan job is sent at the 
same time as a copy job, the ma-
chine may stop while scanning.

Wait until the copy or scan oper-
ation is finished.

A message saying "Read Data 
Error" appears on the computer 
screen.

An error occurred while the ma-
chine was reading data during 
scanning.

Turn off the machine, then check 
that the USB cable is correctly 
connected.
After checking the USB cable, 
turn on the machine again.

A message saying "Machine er-
ror" appears on the computer 
screen.

There may be problem with the 
transmission of commands be-
tween the TWAIN driver and the 
machine.

Check the USB cable connected 
to the machine.