Cisco CATALYST 5500 9 PORT GIGABIT ETHERNET SWITCH MODULE 规格指南
Installing Modules
Catalyst 5000 Family Module Installation Guide
3-6
To install switching modules in Catalyst 5000 family switches, perform these steps:
Step 1
Take the necessary precautions to prevent ESD damage.
Step 2
Choose a slot for the new switching module. Check that you have enough
clearance for any interface equipment that you will connect directly to the
switching-module ports. If possible, place switching modules between empty
slots that contain only switching-module filler plates.
clearance for any interface equipment that you will connect directly to the
switching-module ports. If possible, place switching modules between empty
slots that contain only switching-module filler plates.
Note
If you are installing a WS-X5014 or WS-X5410, these modules require
two adjacent slots.
Step 3
Loosen the captive installation screws securing the switching-module filler plate
(or the existing switching module) to the desired slot.
(or the existing switching module) to the desired slot.
Step 4
Remove the switching-module filler plate (or the existing switching module).
Save the switching-module filler plate for future use.
Save the switching-module filler plate for future use.
Note
If you are removing an existing switching module, refer to the
Step 5
To install the new module, hold the switching-module front panel with one hand,
and place your other hand under the carrier to support the switching module, as
shown in Figure 3-2. Do not touch the printed circuit boards or connector pins.
and place your other hand under the carrier to support the switching module, as
shown in Figure 3-2. Do not touch the printed circuit boards or connector pins.