Kenwood DNX874S 业主指南

 

Ñ

1) Check the installation position of the 

microphone (accessory 4).

2) Clean the installation surface.
3) Remove the separator of the microphone 

(accessory 4), and stick the microphone to 
the place shown below.

4) Wire the microphone cable up to the unit 

with it secured at several positions using tape 
or other desired method.

5) Adjust the direction of the microphone 

(accessory 4) to the driver.

4

Fix a cable with a commercial item of tape.

 

Ñ

1) Engage the catch pins on the extraction key 

(accessory 5) and remove the two locks on 
the lower level. 
Lower the trim plate (accessory 0) and pull it 
forward as shown in the figure.

5

0

Lock

Catch

•  The trim plate can be removed from the top side 

in the same manner.

2) When the lower level is removed, remove the 

upper two locations.

 

Ñ

1) Remove the trim plate by referring to step 1 in 

"Removing the trim plate".

2) Insert the two extraction key (accessory 5) 

deeply into the slots on each side, as shown.

5

3) Lower the extraction key toward the bottom, 

and pull out the unit halfway while pressing 
towards the inside.

•  Be careful to avoid injury from the catch pins on 

the extraction key.

4) Pull the unit all the way out with your hands, 

being careful not to drop it.