Zebra Technologies Corporation MPACTINDR1 用户手册
Beacon Hardware Specifications and Installation
2 - 7
Figure 2-7 USB Style Beacon - MPACT-MB3000-01-WR
When installing numerous beacons, group beacons by category configurations and activate the beacons prior to scanning the
barcodes and associating them with positions in the Toolbox.
barcodes and associating them with positions in the Toolbox.
2. After inserting the beacon(s) into any standard USB power source, associate the beacon in either offline or online mode in
the Toolbox application.
3. From MPact Toolbox, select a site floor plan and an unassigned position for the beacon. Refer to the MPact Location &
Analytics Deployment Guide for information on how to install and deploy the beacon from the Toolbox.
The barcode label should face up toward the ceiling and the smooth front of the beacon should face out toward the aisle where
the mobile client is expected to engage.
the mobile client is expected to engage.
2.4.2 Beacon Battery Replacement
When a beacon’s battery life is less than 20%, the beacon should be prioritized for immediate replacement. The beacon’s
battery is located within a battery tray in the beacon’s housing.
battery is located within a battery tray in the beacon’s housing.
This section includes procedures for replacing batteries for the following part numbers:
•
•
2.4.3 Replacing RB Battery: MPACT-T1B20-000-WR and MPACT-T1B10-000-WR
To replace a beacon’s battery in part number MPACT-T1B20-000-WR and MPACT-T1B10-000-WR:
1. Remove the beacon from the shelving unit (see information on the appropriate beacon part number).
2. With the bottom of the beacon facing up, gently lift each corner of the beacon’s battery tray.
shows the beacon battery housing for part number MPACT-T1B20-000-WR and MPACT-T1B10-000-WR and
MPACT-T1B10-000-WR. In this example, the battery tray is on the right and the corners of the battery tray are marked in
red. When gently lifting each tray corner, slightly push the each corner out to dislodge corners of the tray.
red. When gently lifting each tray corner, slightly push the each corner out to dislodge corners of the tray.
Figure 2-8 Beacon Battery Housing Example:
MPACT-T1B20-000-WR and MPACT-T1B20-000-WR and MPACT-T1B10-000-WR
3. With both tray corners dislodged, gently slide the battery tray open, being careful not to drop the tray.
shows an open battery housing. In this example, the battery tray is a separate piece, along with the battery, on
the right-hand side.