Netgear 12300211 用户手册

A VPN between two or more NETGEAR VPN-enabled routers is a good way to connect 

branch or home offices and business partners over the Internet. VPN tunnels also enable 
access to network resources across the Internet. In this case, use gateways on each end of 
the tunnel to form the VPN tunnel end points. See 

116 for information about how to set up this configuration.

Plan a VPN 

When you set up a VPN, it is helpful to plan the network configuration and record the 
configuration parameters on a worksheet:

Connection Name

N/A

Pre-Shared Key

N/A

Secure Association

N/A

Main Mode

Manual Keys

Perfect Forward secrecy

N/A

Enabled

Disabled

Encryption Protocol

N/A

DES

3DES

Authentication Protocol

N/A

MD5

SHA-1

Diffie-Hellman (DH) Group

N/A

Group 1

Group 2

Key Life in seconds

N/A

IKE Life Time in seconds

N/A

To set up a VPN connection, you need to configure each endpoint with specific identification 
and connection information describing the other endpoint. You configure the outbound VPN 
settings on one end to match the inbound VPN settings on other end, and vice versa.

This set of configuration information defines a security association (SA) between the two 
VPN endpoints. When planning your VPN, you have to make a few choices first:

Will the local end be any device on the LAN, a portion of the local network (as defined by 

a subnet or by a range of IP addresses), or a single PC?

Will the remote end be any device on the remote LAN, a portion of the remote network (as 

defined by a subnet or by a range of IP addresses), or a single PC?

Will either endpoint use fully qualified domain names (FQDNs)? FQDNs supplied by 

on