Redline Communications Inc. AN80IC 用户手册
Red
CONNEX
™
User
AN-80i
Manual
70-00072-01-05-DRAFT
Proprietary Redline Communications © 2008
Page 70 of 94
January 22, 2008
Table 27: CLI - set
PTP PMP Parameter/Description
√
efw
: Enable or disable the Ethernet Follows Wireless function.
off
- Disable
on
- Enable
When Ethernet Follows Wireless is enabled the Ethernet port status is
controlled to reflect the status of the wireless interface. When the AN-80i
detects that the wireless interface has failed (or is manually disabled), the local
Ethernet port is immediately disabled. The Ethernet port is enabled when the
AN-80i registers on the wireless link.
controlled to reflect the status of the wireless interface. When the AN-80i
detects that the wireless interface has failed (or is manually disabled), the local
Ethernet port is immediately disabled. The Ethernet port is enabled when the
AN-80i registers on the wireless link.
√
efwtimeout
: Enter the period (in seconds) the Ethernet port will remain
disabled following loss of connectivity on the wireless interface. Following this
interval, the Ethernet port will be automatically re-enabled to allow
management of the AN-80i.
interval, the Ethernet port will be automatically re-enabled to allow
management of the AN-80i.
√
encmode
: Enable or disable the encryption function.
off
- Disable
on
- Enable
If encryption is enabled, the correct encryption keys must be entered on both
communicating systems.
communicating systems.
√
enckey
: Enter the encryption key. If encryption is enabled, the correct
encryption keys must be entered on both communicating systems. Used only if
encmode is set to 'on'.
<mac>
encmode is set to 'on'.
<mac>
- <MAC address>
√
√
ethmode
: Enter the Ethernet speed and duplex setting.
auto
- Auto-negotiate
10hd
- 10Base-T Half Duplex
10fd
- 10Base-T Full Duplex
10hd
- 100Base-T Half Duplex
100fd
- 100Base-T Full Duplex
√
exit
: Exit from the current mode (go up one level).
√
√
flowctrl
: Enable or disable the flow control function. The Flow control feature
enables the AN-80i to request other Ethernet devices to pause transmission
during busy periods.
during busy periods.
off
- Disable
on
- Enable
√
√
gateway
: Enter the IP address of the default gateway on this segment.
√
√
gmt
: Enter the time offset from GMT (i.e., -5 for EST).
√
grppri
: Group priority.
<id>
- [id number]
<pri>
- <VLAN priority>
√
grpqos
: Group QoS.
<id>
- [id number]
<qos>
- <QoS>
√
grprate
: Group rate.
<id>
- [id number]
<rate>
- <group rate>
√
grpvid
: Group VLAN ID.
<id>
- [id number]
<vid>
- <VLAN ID>