Honeywell International Inc. CS19A 用户手册
4 - 9
scanner is programmed for
(page 4-9), it would be in pre-
sentation mode whenever it is in the stand, and in manual trigger mode when-
ever it is removed from the stand.
ever it is removed from the stand.
Default = Sensor On.
Presentation Mode
Presentation Mode uses ambient light to detect bar codes. The LEDs remain
off until a bar code is presented to the scanner, then the LEDs turn on automat-
ically to read the code. If the light level in the room is not high enough, Presen-
tation Mode may not work properly.
Note: If you are using a cordless device in Presentation Mode, the battery will
off until a bar code is presented to the scanner, then the LEDs turn on automat-
ically to read the code. If the light level in the room is not high enough, Presen-
tation Mode may not work properly.
Note: If you are using a cordless device in Presentation Mode, the battery will
not charge unless the power supply is plugged into the base’s auxiliary
power port.
Presentation LED Behavior after Decode
When a scanner is in presentation mode, the LEDs remain on and continue
scanning for a short time after a bar code is decoded. If you wish to turn
the LEDs off immediately after a bar code is decoded, scan the LEDs Off
bar code, below.
scanning for a short time after a bar code is decoded. If you wish to turn
the LEDs off immediately after a bar code is decoded, scan the LEDs Off
bar code, below.
Default = LEDs On.
* Sensor On
Sensor Off
Presentation Mode
* LEDs On
LEDs Off
Preliminary Draft