Honeywell International Inc. CS19A Manuale Utente

4 - 9

scanner is programmed for 

(page 4-9), it would be in pre-

sentation mode whenever it is in the stand, and in manual trigger mode when-
ever it is removed from the stand.  

Default = Sensor On.

Presentation Mode uses ambient light to detect bar codes.  The LEDs remain 
off until a bar code is presented to the scanner, then the LEDs turn on automat-
ically to read the code.  If the light level in the room is not high enough, Presen-
tation Mode may not work properly.  
Note: If you are using a cordless device in Presentation Mode, the battery will 

not charge unless the power supply is plugged into the base’s auxiliary 

power port.

When a scanner is in presentation mode, the LEDs remain on and continue 
scanning for a short time after a bar code is decoded.  If you wish to turn 
the LEDs off immediately after a bar code is decoded, scan the LEDs Off 
bar code, below.  

Default = LEDs On.

Preliminary Draft