Honeywell International Inc. THM4000R02 用户手册

WIRELESS SETUP

M28481

M28483

NO

YES

CONNECT MORE?

M28482

1  Make sure the CONNECT light on the

wireless receiver is flashing.

2  Press CONNECT at the Portable Central

Controller. There will be a short delay as the 
Portable Central Controller seeks a signal
from the wireless network.

3  When the screen displays "Connected,"

press 

DONE.

4  Press NO at the next screen to save and exit.

(Or press

YES and repeat steps 1-4 to link 

another receiver.)

1  Make sure the CONNECT light on the

wireless receiver is flashing.

2  Press and release the CONNECT button on the 

back of the sensor.

3  Check remote controller to verify that the 

outdoor sensor is working. After about 
15 seconds, the remote controller should 
display outdoor temperature and humidity.

Press to link
another receiver

Press to save
and exit

If E1 appears, see error codes on page 10.

The linking procedure may time out if there is 
no keypress within 15 minutes. To begin again, 
press and hold the blank space (or arrow, if
present) in the lower right corner of the screen
until the display changes (about 3 seconds).

Press and release