Zebra Technologies Corporation P430I-UHF 用户手册
Installation and Setup
Loading Cards
980470-001 Rev. A
P430i User’s Manual
19
2.
Remove all wrapping from the card deck.
3.
Holding the card deck by the sides, hold it vertically against a flat surface such as a desktop. If the deck is
too thick for your hand to hold it comfortably, use about half a deck at a time.
too thick for your hand to hold it comfortably, use about half a deck at a time.
4.
Push the stack back and forth to an angle of about 45
°
from vertical, so as to separate all of the cards.
5.
Restore the card stack to its original squared-off condition, and place the cards in the input hopper.
6.
Note that there will be a “gap” in the card stack, with several cards lying flat and the cards above angled
upward, as shown in the exaggerated drawing below. This is normal and ensures proper feeding.
upward, as shown in the exaggerated drawing below. This is normal and ensures proper feeding.
Note •
Static charges and edge burrs from the card die-cutting process can render individual
cards stuck together with significant adhesion force. These cards must be physically
separated from each other before inserting into the feeder; if not separated, feeding or
printing problems may occur.
separated from each other before inserting into the feeder; if not separated, feeding or
printing problems may occur.
Note •
Do not try to eliminate the gap by pressing down on the card stack in the input
hopper; this can cause misfeeds.