JVC KENWOOD Corporation 407110 用户手册
24
5 BASIC COMMUNICATIONS
AUTO ZERO-BEAT
Use Auto Zero-beat before transmitting to tune in a
CW station. Auto Zero-beat automatically and exactly
matches your transmit frequency with the station you
are receiving. Neglecting to do this will reduce your
chances of being heard by the other station.
CW station. Auto Zero-beat automatically and exactly
matches your transmit frequency with the station you
are receiving. Neglecting to do this will reduce your
chances of being heard by the other station.
1 Tune to the CW signal using the Tuning control.
2 Press
[CW T. (AGC OFF)] to start Auto Zero-beat
while CW is selected for the operating mode.
s
s
SO
s
disappears.
s
frequency is restored.
3 To quit Auto Zero-beat, press [CW T. (AGC OFF)]
or [CLR].
Note:
◆ When using Auto Zero-beat, the matching error is normally
◆ When using Auto Zero-beat, the matching error is normally
within ±5 Hz.
◆ Auto Zero-beat may fail if the keying speed of the target
station is too slow or if some interference is present.
◆ When
the
RIT function is ON, only RIT frequencies change
to make the Auto Zero-beat adjustment.
TX SIDETONE/ RX PITCH FREQUENCY
As you send CW, you will hear tones from
THE
THE
28
On this transceiver, the frequency of the sidetone and
28
28
40
to select the frequency that is most comfortable for
you. The selectable range is from 300 Hz to 1000 Hz
IN
IN
4O
06
. The selections range from 1 to
20
and
/&&
10
Note:
◆ The position of the AF control does not affect the volume of
◆ The position of the AF control does not affect the volume of
THE
◆
OF
CARRIER LEVEL
When using AM, CW, or FSK mode, you can adjust
the carrier level.
the carrier level.
1 Press and hold [MIC (CAR].
s
display.
2 Turn the MULTI/CH control so that the ALC meter
reads within the limits of the ALC zone.
s
that the ALC meter just begins to indicate.
3 Press and hold [MIC (CAR] again or press [CLR]
to complete the setting.
POWER ON MESSAGE
Each time you switch the transceiver ON,
h+%.7//$v
h+%.7//$v
1 Press [MENU], then press [Q-M.IN]
turn the MULTI/CH control to access Menu No
01
.
2 Press [M.IN]
the message.
3 Move the cursor to the left or right by pressing
[Q-M.IN] or [Q-MR].
4 Press [M.IN]
CH control to select your desired character.
s
pressing [CL].
5 Repeat steps 3 and 4 to enter the remaining
characters.
6 Press
[MENU] to set the entry and exit character
entry mode.
s
entry mode and exit the Menu mode.