Wulfsberg Electronics Division 2000-UHF1 用户手册
Wulfsberg Electronics
P-2000 and C-2000/RT-2000 Operator’s Manual
Document 150-041102 Revision A
Page 12 of 37
Selecting a Standby Channel Using the Cursor/Tune Knob
When the P-2000 first powers on, the selected channels will be set to those that were active when the unit was
powered down. To select a different preset channel, do the following:
powered down. To select a different preset channel, do the following:
Using the Select Knob, put the square cursor around the channel number. Turn the Tune Knob until the channel is
your desired channel. If you wish to make this your active channel, push the transfer button.
your desired channel. If you wish to make this your active channel, push the transfer button.
Selecting a Channel Using the Keypad
Occasionally, it is desirable to select a preset channel by entering its number via the keypad, rather than dialing it in
with the Select/Tune knobs. This can be performed as follows.
with the Select/Tune knobs. This can be performed as follows.
When the user presses the CHAN key, the keypad channel entry mode will begin. This mode allows the user to tune
a channel by inputting the desired channel’s number into a field via the keypad. The figure below depicts this mode
of channel tuning. If no keypad input is received for more than 4 seconds, the operation will automatically cancel.
Pressing the HOME key operation will also cancel the operation. When the user presses the ENTER key, the
channel with the number input into the field will be loaded. If the input channel number is invalid, an error tone will
sound, and the previous “good” channel will be reinstated.
a channel by inputting the desired channel’s number into a field via the keypad. The figure below depicts this mode
of channel tuning. If no keypad input is received for more than 4 seconds, the operation will automatically cancel.
Pressing the HOME key operation will also cancel the operation. When the user presses the ENTER key, the
channel with the number input into the field will be loaded. If the input channel number is invalid, an error tone will
sound, and the previous “good” channel will be reinstated.