Honeywell International Inc. 8DL5800PIR-OD 用户手册
5800-OD Wireless Outdoor Motion Sensor – Installation Instructions
–
2
–
4
Mount the Sensor
WALL MOUNTING
1.
Install the Back Box on the
wall with the two T4 x 20
mounting screws.
wall with the two T4 x 20
mounting screws.
UP
2.
Insert the batteries (see
Install/Replace the Battery),
then secure the Detector to the
Back Box.
Install/Replace the Battery),
then secure the Detector to the
Back Box.
3.
Fasten with four (4) screws.
4.
Perform Settings & Adjustments.
5.
Perform a Walk Test.
6.
Secure the Cover with the Captive Lock Screw.
POLE MOUNTING
1.
Use a pole with an outside
diameter of 43-48mm
(1.69-1.89").
diameter of 43-48mm
(1.69-1.89").
2.7- 4ft.
0.8 - 1.2m
0.8 - 1.2m
2.
Attach the Brackets to the Back
Box with two M4 x 30 screws.
Box with two M4 x 30 screws.
3.
Using the Pole Brackets and four
M4 x 30 screws, fasten the Back
Box to the pole.
M4 x 30 screws, fasten the Back
Box to the pole.
UP
4.
Insert the batteries (see
Install/Replace the
Battery), then mount the
Detector on the Back Box
and fasten with four (4)
screws.
Install/Replace the
Battery), then mount the
Detector on the Back Box
and fasten with four (4)
screws.
5.
Perform Settings &
Adjustments.
Adjustments.
6.
Perform a Walk Test.
7.
Secure the Cover with the
Captive Lock Screw.
Captive Lock Screw.
5
Perform Settings & Adjustments
SET THE DETECTION LENGTH
Note: The length of the lower detection area determines the detection length.
The upper detection area stays parallel to the ground at all times. The lower detection area can be adjusted as shown below by the switch
position.
Detection length is therefore limited by the length of the lower detection area since both upper and lower areas have to be blocked at the
same time to activate the sensor.
IMPORTANT:
The upper detection area stays parallel to the ground at all times. The lower detection area can be adjusted as shown below by the switch
position.
Detection length is therefore limited by the length of the lower detection area since both upper and lower areas have to be blocked at the
same time to activate the sensor.
IMPORTANT:
This sensor detects temperature differences between the moving object and the background temperature in the detection area to produce a
valid detection.
valid detection.
If the object does not move, the sensor will not detect it.
If there is traffic near the detection area, adjust the detection area length 1.5 to 2.0m (5 to 7ft) back from traffic.
Detection Length
Detection Length
Detection Length
UPPER and LOWER beams are blocked,
detection is made.
detection is made.
Only the LOWER beam is blocked,
detection is not made.
detection is not made.
Only the UPPER beam is blocked, detection is
not made.
not made.