Andrew Wireless Innovations Group RPT-MR701 用户手册
User’s manual for Repeater MR801B Power
M0067A0A.doc
Id.-No 151111
Page 27
02-JUNE-99
If the reason for the alarm has been cleared or if the alarm should continue, a new alarm
message will not be repeated. If there was an interruption of at least one second after
acknowledgement, a new alarm message will be generated.
message will not be repeated. If there was an interruption of at least one second after
acknowledgement, a new alarm message will be generated.
3.4.2 Status report
Two instructions enable the operator to gain knowledge of the system status. Typing the GET
command will be responded by a listing of all settings of the Repeater. STATUS will be
responded by a listing of all individual status information.
command will be responded by a listing of all settings of the Repeater. STATUS will be
responded by a listing of all individual status information.
An examples is listed below for a GET1* (REP1009V1.xx) and STATUS report. The listing
contains random data to demonstrate in which way these messages appear.
contains random data to demonstrate in which way these messages appear.
*:
Due to the fact that the report is very long, the GET report can be split in two parts. You have to type GET1 to
see the first and GET2 to see the second part.
The complete listing of the dialogue language with the processor of the control module
including the instructions to and the messages from the system is available as a separate
manual.
including the instructions to and the messages from the system is available as a separate
manual.
figure 3-5 Example of a GET1 report